Ok the story goes on.
It’s time for the bottom cover it’s a little bit tricky as you can see on the plan.
On the upper side it should pass the inside of the cylinder, to the left a hole for the column and to the right two holes for the other column.
On the bottom side a center hole for the piston rod. But as you can see there is no steam packing so I decided to modified little Kathy a bit.
First some turns in the lathe for the piston road.
Then I make the steam packing.
The top side passing for the cylinder.
Drilling for the column.
Drilling and threading for the cylinder.
Assembling the parts so far.
I am still waiting for some equipment so I have to do this small work wail I am waiting.
I’ll be back